Germination Behavior and Geographical Information System-Based Phenotyping of Root Hairs to Evaluate the Effects of Different Sources of Black Soldier Fly (Hermetia illucens) Larval Frass on Herbaceous Crops

: Insect larval frass has been proposed as a fertilizer and amendment, but methods for testing its effects on plants are poorly developed and need standardization. We obtained different types of black soldier fly (Hermetia illucens) frass via the factorial combination of (a) two insect diets, as follows: G (Gainesville = 50% wheat bran, 30% alfalfa meal, 20% maize meal) and W (43% sheep whey + 57% seeds); (b) two frass thermal treatments: NT = untreated and T = treated at 70 °C for 1 h. We tested the effects on the germination of cress (Lepidium sativum L.) and wheat (Triticum durum Desf.) by applying 1:2 w:w water extracts at 0, 25, 50, 75 and 100% concentration. Standardizing frass water content before extraction affected chemical composition. Frass extracts showed high electrical conductivity (8.88 to 13.78 mS cm-1). The W diet was suppressive towards Escherichia coli and showed a lower content of nitrates (e.g., WNT 40% lower than GNT) and a concentration-dependent phytotoxic effect on germinating plants. At 25% concentration, germination indices of G were 4.5 to 40-fold those at 100%. Root and shoot length and root hair area were affected by diet and concentration of frass extracts (e.g., root and shoot length in cress at 25% were, respectively, 4.53 and 2 times higher than at 100%), whereas the effects of the thermal treatment were few or inconclusive. On barley (Hordeum vulgare L.) grown in micropots on a silty loam soil, root mass was reduced by 37% at high extract concentration. A quick procedure for root hair surface area was developed based on the geographic information system (GIS) and may provide a fast method for incorporating root hair phenotyping in frass evaluation. The results indicate that below-ground structures need to be addressed in research on frass effects. For this, phyotoxicity tests should encompass different extract dilutions, and frass water content should be standardized before extraction in the direction of canonical procedures to allow comparisons.